3.5" ID Red Heat Shrink Tube 2:1 ratio wrap (2 feet) polyolefin ft/inch 90mm

Description

You will receive
2 feet
of RED 3.5" (90mm)
I.D. (inner diameter)
tubing per quantity ordered
The 90mm ID tube is approximately 5.6" wide while flattened before use.
If you need a tube that is about 3.5" wide while flattened, you instead want the 50mm ID tube or the 60mm ID tube.
You can find them here:
https://www.ebay.com/itm/203049616047
Smaller sized tubes can be found here:
https://www.ebay.com/itm/203049859100
Tubes with adhesive inner wall (dual-wall tubing) can be found here: https://www.ebay.com/itm/203049856945
If you need a longer uncut continuous length of tubing, it is usually available upon special request - add a note or message to request!
Add multiple of my items to your cart to unlock higher discounts!
Premium polyolefin heat shrinkable tubing
2 to 1 shrinkage ratio; will shrink to half of the stated inner diameter
All stated diameters are
internal diameter pre-shrunk measurements
Small printing on the tubing states the diameter and temperature range (some colors/sizes may have no printing)
UNDERSTANDING THE SIZING CHART:
Nominal Internal Diameter - this is the starting size, referred to in the title of each post
Actual Internal Diameter - the tubing is actually slightly larger than the nominal size to ensure a proper fit!
Approximate Flat Width - larger sizes start out folded down flat, this is a flat dimension for your reference
Shrunk Internal Diameter - the tubing will shrink down to smaller than this size, guaranteed!