1.0" ID Red Heat Shrink Tube 2:1 ratio polyolefin wrap (2 feet) 1" inch 25mm

Description

You will receive
two feet
of
RED
1" (25mm)
I.D. (inner diameter)
tubing
per quantity ordered
The 25mm ID tube is approximately 1.6" wide while flattened before use. Diameter and width are not the same thing!
If you need a tube that is about 1" wide while flattened, you want the 16mm ID tube.
You can find that here:
https://www.ebay.com/itm/203049859100
Larger sized tubes can be found here:
https://www.ebay.com/itm/203049616047
Tubes with adhesive inner wall (dual-wall tubing) can be found here: https://www.ebay.com/itm/203049856945
If you need a longer length of tubing, it is usually available upon request - click "Contact Seller" and message us, we answer fast!
Add multiple of our products to your cart to unlock higher discounts!
Premium polyolefin heat shrinkable tubing
2 to 1 shrinkage ratio; will shrink to half of the stated inner diameter
All stated diameters are
internal diameter pre-shrunk measurements
Small printing on the tubing states the diameter and temperature range (some colors/sizes may have no printing)
UNDERSTANDING THE SIZING CHART:
Nominal Internal Diameter - this is the starting size, referred to in the title of each post
Actual Internal Diameter - the tubing is actually slightly larger than the nominal size to ensure a proper fit!
Approximate Flat Width - larger sizes start out folded down flat, this is a flat dimension for your reference
Shrunk Internal Diameter - the tubing will shrink down to smaller than this size, guaranteed!